Rear end and Walls Started!

Finished up the rear end this stretch off. The horizontal bar at the back will eventually be cut in the middle for the entry door but I left it solid during construction to make sure everything stays aligned since welding can cause some distortions.

Last stretch did two double-miter pieces in the back corners of the wheel wells, I need to do two more for the back corners of the camper and I was not looking forward to it. The rear corners I had three 1x1" rectangular tubes coming out and overlapping in at the back corner of the camper frame. When I went to build it these overlaps were terrible to try and fit up especially for the double miters.

I decided to cut the rear corners out after wasting hours trying to fit the double miter in. There was a much better way that's probably stronger as well by spacing out the rear corners out so each tube doesn't overlap. If anything, it distributes the loads better.

To end the stretch I started on some of the corner posts so I can get rolling on the walls proper, it's starting to look like a camper!